hesheng stone machinery,stone cutting machine,stone polishing machine,bridge cutting machine,block cutting machine,bridge saw,stone machine

Stone cutting machine using stone precautions

Time：2018-01-27 Hits：3070

Stone cutting machine can be carried out at different depths of the stone cutting, can be less than 1m3 below the stone processing, turning waste into treasure, greatly saving stone resources, but also conducive to the protection of the environment. Various types of stone can be mechanical Cutting, processing more efficient, combined with the effective use of small stones, so that lower production costs.
Precautions:
1, the machine has a directional, non-reversal, otherwise it will cause damage to the machine and personal safety.
2, machine operation, the fuselage must be grounded, non-ground work is strictly prohibited.
3, promptly clean up the workbench, stop pumping water and sediment sink.
4, to prevent heavy impact on the work surface.
5, the machine when not in use for a long time, should be stored in a dry and clean place.
Tile cutting machine safe operation rules:
1. Do not have training to master operating skills shall not operate the cutting machine. To operate to obtain the custodian's permission, and to have someone to guide and custody.
2. Work wear before labor insurance complete, cuffs, placket to tie tight. Wear safety goggles to prevent eye injuries.
3. Before work to check the various mechanical components (such as saw blades, countertops, screws, chains, motors, switch buttons, etc.) are normal. If the problem should be reported repair repair workshop, troubleshooting can only boot.
4. cracked, not smooth, edentulous teeth and blunt saw blade can not be used. When replacing the saw blade, the power must be cut off. The saw blade should be installed securely and perpendicular to the shaft centerline. There should be no beating during operation.
5. Check the protective shield is complete and effective, shall not be arbitrarily dismantled. Activities of the protective shield shall not be free to migrate.
6 boot idle machine running for 2-3 minutes, check the operation of the blade is normal, either the test machine or normal use, the blade is not allowed to run directly on the blade. Test machine at the same time observe the cooling water supply is normal.
7. Operators should not be allowed to leave their jobs after the cutting machine is started, and must be shut down before leaving.
8 work, the kerf on the knife must stop running the blade, the knife is completed after the start of the film cutting operation.
9. When cutting, the operator is forbidden to approach the blade by hand or cross the blade, and supervise other people at any time.
10. After the cutting is completed, the body should be turned back to the stop position to ensure that the saw blade has entered the protective cover to prevent accidental injury due to inadvertent people touching the saw blade that has not stopped rotating due to inertia.
Jinjiang City, Fujian Province and Sheng Machinery Co., Ltd., located in the southern suburbs of Quanzhou in the Golden Triangle, Fujian's top ten civilized ancient town - Anhai Town Wushan Industrial Zone. In recent years, the company with effective scientific management, strong technical force, advanced production equipment and manufacturing processes, superb technology, has developed a hydraulic locking column stone cutting machine, double locking bridge stone machine, automatic granite Strip polishing machine, automatic combination of trimming machine, automatic sandblasting machine, mining machine cut, infrared bridge cutting machine, flat bottom machine, the bridge combination of cutting machines and so a total of 18 series of more than 40 varieties of specifications Mechanical products.